Table of Contents
- qBackup
- Overview
- Setup Guide
- Step 1: Install, start qBackup and click +New in top left corner
- Step 2: Name your Project and select S3 Compatible Storage in Storage Type, fill in the credentials and click Ok to create project
- Step 3: Select include to add your files and folders
- Step 4: Once Project is saved, select your backup on left hand side and select Backup to run the job
- Step 5: Confirm job was successful, indicated by “Completed status”
qBackup
Learn how to use qBackup (app version 1.17.0.1) to store backups on the ScPrime distributed datacenter using the XNS Relayer
Overview
qBackup is an app that backs up your files to your cloud storage account. qBackup is compatible with S3 protocol destinations, so it makes a good match for XNS storage.
Read this guide for how to configure qBackup to backup to XNS.
Prerequisites
- Get your qBackup installation files from here
- Install the XNS Relayer
- Configure the XNS Relayer’s Endpoint Access Key and Endpoint Secret Key
Setup Guide
Step 1: Install, start qBackup and click +New in top left corner
Step 2: Name your Project and select S3 Compatible Storage in Storage Type, fill in the credentials and click Ok to create project
Storage Type | [S3 Compatible Storage] | S3 Compatible storage |
Access Key: | [Endpoint Access Key (Username)] | This is defined in the XNS Relayer General Configuration. |
Secret Key: | Endpoint Secret Key (Password) | This is defined in the XNS Relayer General Configuration. |
Endpoint | [Your IP : Port] | This is the IP or hostname of your XNS Relayer the port defined in the Advanced Settings (‘MINIO_PORT’, default is 9000). |
Bucket | [Select Bucket] |